Snap to Grid in Wireframe editor

By default, when you move components in the Wireframe editor, it does not snap-to-grid. However, if you want to snap components by a certain distance when you move them, it can be configured in "Grid Settings" as shown below. Once enabled, the settings are saved with the project.


Configure snap-to-grid settings


1Open the grid settings by selecting ‘Pages’ or by clicking ‘Project’ from the top menu in the Wireframing editor sidebar.


Grid Settings (11).gif


2In the grid settings, enable ‘Snap to Grid’.


Grid Settings (10).gif


3Enter the desired snap position value, which determines the spacing for component movement.


Grid Settings (9).gif


4Components will now move based on the specified snap position, ensuring consistent alignment and spacing.


Grid Settings (12).gif




Rate this article
great ok bad
For more questions - Contact Us
...